Baritone neck

Unrelated: guinea pigs perfecting hover technology.

DC Kunkle has advise for attaching guitar necks. This is specifically the instructions for his baritone neck:

Long scale conversion neck for the Tele style body with no modification necessary for intonation, I start with the 25.5" scale and moved it out two more frets to achieve the 28.629" scale. There's a 10-15 business day build/handling time on these. I try to keep it to 10 but when it gets real busy, it can sometimes take a little longer.

My standard Specs for this neck are as follows:

·        28.629" scale.

·        one  piece Eastern Hard Rock Maple (a standard for bolt on necks)

·        single action truss rod

·        black walnut skunk stripe

·          T  style peg head with stepped tuner holes to accommodate the die cast Schaller/Gotoh style tuners. The big hole diameter is 13/32" =.404" =10.26mm The upper small hole diameter is 21/64" = .325" = 8.28mm

·        T style heel

·         1 & 11/16^th  ” at Nut

·        2 3/16^th  ” at Heel

·        14" radius Hard Maple fret board

·        1/8^th “ flat bottom nut slot, (nut not included)  if you would like a nut, see extras

·        23 frets

     Comes with no mounting holes (see extras)

11  .110" wide, .053" tall frets installed,     I spray two coats of lacquer on the fret board. If you plan to add more lacquer I will sand with 320 dry then buff slightly with fine scotch guard then install the frets. This makes it easy to add more lacquer if you choose to do so. Let me know at time of purchase if you would like me to do that. When I do add more lacquer after the frets are installed, I take and cut masking tape into thin strips by laying it on a peace of glass and using a straight edge and utility knife blade. ( I usually use 12" to 16" strips) You can tailor the width of the strips to best cover the tops of the frets but letting the lacquer bridge the fret board and bottom edge of the frets.   - no fret work. (see extras)

·        7/32" black position marker dots

·        3/32" black side dots

·        standard back cut is vintage U, similar to a 54 T/S round back or a 59 L/P round back, .875" at the first fret, .975" at the twelfth fret.

      EXTRAS    If you choose to have any extras  done you can commit to buy but don't pay, send a message with which extras you would like and I will send an invoice  for the correct amount.

     Fret work.     I can do a fret mill (level) crown and polish the frets for you as an option for an extra $25, if you do not have the experience to do this yourself, this option comes highly recommended. 

     Bone nut.      For an extra $25. I can rough in a bone nut cut in with nut files and left a little high (factory) left loose so you or your tech can tailor it to your own taste. To secure when your ready just put a dab of wood glue on the outside bottom  two edges, install on neck and tighten the strings, the outside two strings is all you need to tighten, let sit for a hour or so and your good to go. You can put all the glue you want to glue this on, but the more you put on the harder it is to replace later on.

      Drill mounting holes.    For an extra $5. I can drill those for you.

     The neck comes with two coats of nitrocellulose lacquer, not meant to be perfect, but it's a good hard finish that will let you put your project together with out the hassle of doing finish work yourself.